Asus RS740-E7-RS24-EG - Manual (Page 44)

Chapter 2: Hardware setup 2-20
3. Release the screws on each side of the
drive tray to release the drive tray metal
beam.
The drive tray metal beam provides
horizontal support to the empty drive
tray and prevents the drive tray from
being bent or deformed.
metal beam
4. Orient the SSD with its SATA connector
facing the rear then place the SSD into
the tray.
Ensure that the SSD is fitted firmly inside
the drive tray and that the four screws of
the SSD matches the four screw holes of
the drive tray.
drive tray screw hole
SSD screw hole
SSD
6. Align and insert the SDD and drive tray
assembly into the drive bay.
7. Push the drive tray all the way into the
drive bay then push the tray lever until it
clicks into place.
8. Repeat steps 1—7 if you want to install
the second SSD drive.
5. Secure the SDD to the drive tray with
four (4) 2.5-inch HDD tray screws that
is bundled with your server.