Rebuilding the raid with a new hard disk – Asus RS740-E7-RS24-EG User Manual

Page 164

6-30

Chapter 6: RAID configuration

The utility immediately starts rebuilding after the disk is selected. When done, the

status of the degraded RAID volume is changed to “Rebuild”.

Press to exit Intel Rapid Storage Technology and reboot the system.

Select Start > Programs > Intel Rapid Storage > Intel Rapid Storage Console or click

the Intel Rapid Storage Technology tray icon to load the Intel Rapid Storage Manager

utility.

From the View menu, select Advanced Mode to display the details of the Intel Rapid

Storage Console.

From the Volumes view option, select RAID volume to view the rebuilding status. When

finished, the status is changed to “Normal”.

Rebuilding the RAID with a new hard disk

If any of the SATA hard disk drives included in the RAID array failed, the system displays the

status of the RAID volume as “Degraded” during POST. You may replace the disk drive and

rebuild the RAID array.
To rebuild the RAID with a new hard disk:
1.

Remove the failed SATA hard disk and install a new SATA hard disk of the same

specification into the same SATA Port.

Select a destination disk with the same size as the original hard disk.

Reboot the system then follow the steps in section Rebuilding the RAID with other non-

RAID disk.

[ESC]-Exit

[ENTER]-Select Menu

[ ]-Select

Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 3.6.0.1023

[

MAIN MENU

]

[

DISK/VOLUME INFORMATION

]

RAID Volumes: *=Data is Encrypted

ID Name Level1 Strip Size Status Bootable

1 Volume0 RAID1(Mirror) N/A 149.0GB

Rebuild

Yes

Physical Devices:

Port Drive Model Serial # Size Type/Status(Vol ID)

1 ST3160812AS 9LS0F4HL 149.0GB

Member Disk(0)

2 ST3160812AS 3LS0JYL8 149.0GB

Member Disk(0)

Volumes with “Rebuild” status will be rebuilt within the operating system.

3. Reset Disks to Non-RAID

4. Exit

1. Create RAID Volume

2. Delete RAID Volume