Asus RS740-E7-RS24-EG - Manual (Page 42)

Chapter 2: Hardware setup 2-18
4. Release the four (4) screws on the side of
the 3.5-inch SATA / SAS HDD.
Set aside the screws for later use.
3. Firmly hold the tray lever and carefully pull the drive tray out of the bay. Place the drive
tray in a clean and flat surface.
5. Remove the old 3.5-inch SATA / SAS
HDD from the tray.
Prepare the new 3.5-inch SATA / SAS
HDD.
6. Orient the new 3.5-inch SATA / SAS
HDD with its SATA connector facing
the rear then place the SATA / SAS
HDD into the tray.
Ensure that the four screw holes of
the drive tray matches the screw
holes of the 3.5-inch SATA / SAS
HDD.
spring lock
tray lever
3
2