Hardware setup, 2 layout contents – Asus P4T-M User Manual
Page 15
15
3. HARDWARE SETUP
ASUS P4T-M User’s Manual
3.2 Layout Contents
Expansion
1) RIMMA1/A2/B1/B2
p.17 184-Pin System Memory Support
2) CPU
p.19 Central Processing Unit (CPU)
3) HEATSINK
p.20 CPU Heatsink Retention Module Installation
3) PCI1/2/3
p.23 32-bit PCI Bus Expansion Slots
4) AGP 4X
p.25 Accelerated Graphics Port (AGP 4X) Slot
Connectors
1) PS2KBMS
p.26 PS/2 Mouse Connector (6 pin female)
2) PS2KBMS
p.26 PS/2 Keyboard Connector (6 pin female)
3) PRINTER
p.27 Parallel Port Connector (25 pin female)
4) COM1
p.27 Serial Port Connector (One 9 pin male)
5) USB
p.28 Universal Serial Bus Ports (Two 4 pin female)
6) RJ45
p.28 Fast Ethernet Port Connector (optional)
7) IEEE 1394
p.28 IEEE-1394 Controller Con.(optional)(6 pin male)
8) GAME_AUDIO
p.29 Joystick/MIDI Connector (15 pin female)
9) GAME_AUDIO
p.29 Audio Port Connectors (Three 1/8” Female)
10) FLOPPY
p.29 Floppy Disk Drive Connector (34-1pin)
11) PRIMARY/SECONDARY IDE p.30 Primary/Secondary IDE Connectors (Two 40-1 pin)
12) USB2
p.30 USB Header (10-1 pin)
13) IA
p.31 Internal Audio (4 pin SPDIF_OUT, CD_IN, AUX)
14) 1394_CON
p.31 IEEE-1394 Controller Header (optional)(Two 8 pin)
15) CPU_FAN, PWR_FAN
p.32 CPU, PWR, CHA Fan Connectors (Three 3 pin)
CHA_FAN
16) SPDIFO
UT
p.33 Digital Audio Interface Connector (3 pin WOL)
17) WOLCON
p.33 Wake-On-LAN Connector (3 pin)
18) IR
p.34 Standard Infrared (SIR) Module Connector (5-pin IR)
19) AFPANEL
p.34 iPanel Connector (24-1 pin)
20) ATXPWR, ATX12V
p.35 ATX 12V Power Supply Connectors
21) IDELED
p.35 IDE Activity LED (2-pin IDELED)
22) PWRLED (PANEL)
p.36 System Power LED Lead (3 -1 pin)
23) KEYLOCK (PANEL)
p.36 Keyboard Lock Switch Lead (2 pin)
24) SPEAKER (PANEL)
p.36 System Warning Speaker Connector (4 pin)
25) MSG.LED (PANEL)
p.36 System Message LED (2 pin)
26) SMI (PANEL)
p.36 System Management Interrupt Switch Lead (2 pin)
27) PWRSW (PANEL)
p.36 ATX Power / Soft-Off Switch Lead (2 pin)
28) RESET (PANEL)
p.36 Reset Switch Lead (2 pin)
Layout Contents
3. H/W SETUP