Asus P6X58-E WS User Manual
Page 56

3. Marvell
®
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1-2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
• The SATA6G_E1/E2 (navy blue) connectors are for data drives only. ATAPI
device is not supported.
• You must install Windows
®
XP Service Pack 3 or later versions before using
Serial ATA hard disk drives.
• When using hot-plug and NCQ, set the Marvell Storage Controller
item in the BIOS to [Enabled]. Refer to section 3.5.6 Onboard Devices
Configuration for details.
• Press
or delete a RAID configuration.
• If you want to install a Windows operating system to a RAID configuration
created using the Marvell SATA controller, you have to create a RAID driver
disk using the motherboard support DVD and load the driver during OS
installation. For 32/64bit Windows XP OS, load first the Marvell shared
library driver, and then load Marvell 91xx SATA Controller Driver.
For Windows Vista / Windows 7 OS, load only the Marvell 91xx SATA
Controller Driver.
2-32
Chapter 2: Hardware information