Asus M4A88T-I DELUXE - Manual (Page 32)

3. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for an ATX power supply. The plugs from the power supply are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
• We recommend that you use an ATX 12V Specification 2.0-compliant power supply unit
(PSU) with a minimum of 200W power rating. This PSU type has 24-pin and 4-pin power
plugs.
• If you intend to use a PSU with 20-pin and 4-pin power plugs, ensure that the 20-pin
power plug can provide at least 15 A on +12 V and that the PSU has a minimum power
rating of 200W. The system may become unstable or may not boot up if the power is
inadequate.
• DO NOT forget to connect the 4-pin ATX +12V power plug. Otherwise, the system will
not boot up.
• We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
• If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
M4A88T-I DELUXE
M4A88T-I DELUXE ATX power connectors
EATXPWR
GND +5 Volt
s
+5 Volt
s
+5 Volt
s
-5 Volt
s
GND GND GND PSON# GND -12 Volt
s
+3 Volt
s
+3 Volt
s
+12 Volt
s
+12 Volt
s
+5V Standby
Power OK
GND
+5 Volt
s
GND
+5 Volt
s
GND
+3 Volt
s
+3 Volt
s
ATX12V
PIN 1
PIN 1
+12V DC +12V DC
GND GND
Chapter 1: Product introduction 1-20