Net Optics iBypass 40G - Manual (Page 14)

14
Step 4
Configure the IP
The iBypass 40G switch ships with a default address. You can decide to use the
default address, assign a static IPv4 or IPv6 IP address or use DHCP to assign an
address.
To configure the system with a static IPv4 or IPv6 address, do the following:
1. At the CLI prompt, type the following to set the address mode to static:
set network mode static
2. Type the following to set the IPv4 address:
set network ipaddress where is the IPv4 address
3. Type the following to set the network mask:
set network netmask where is the netmask.
4. Type the following to set the gateway:
set network gateway where is the gateway address.
5. Type reboot host, to reboot the system. This is required for the new address to
take effect. The new IP address will display in the LCD.
After setting the IP address, connect the Management port to the network, so
that you can access the device remotely over SSH or launch the Web UI with
the new IP address.