Net Optics iBypass 40G - Manual (Page 12)

12
Step 3 (cont.)
Option 2 - Connect PC to the Console Port
1. Connect a PC running terminal emulation software to the iBypass 40G Switch
Console port with the supplied DB9-RJ45 console cable. See Figure 6.
2. Launch the terminal emulation software, such as HyperTerminal or minicom,
and set the communication parameters to 115,200 baud, 8 data bits, no parity,
1 stop bit, and no flow control.
3. At the prompt, enter admin for the user and netoptics for the password.
4. Change the password for the admin account by entering the following
command at the prompt:
modify user password admin
where is the new password for the admin account and
is your password entered again.
5. Go to Configure the IP section and follow the instructions to set a new IP
address.
For more information about using the iBypass 40G Switch CLI, enter help to display
command information or see the iBypass 40G Switch User Guide for more details.