Q-Tech QTV716 Sine Wave - Manual (Page 7)

QTV714, QTV715 and QTV716
Sine-Wave 24 Flat Pack
Sine-Wave 24 Flat Pack
REV.
Q-TECH Corporation
10150 W. Jefferson Blvd.
Culver City, CA 90232
SIZE
A
CAGE NO.
51774
Sheet 7 of 7 1.0
22X .100 TYP.
12
24
13
1
Q-TECH
PART NUMBER
FREQUENCY
D/C USA
S/N
.210 MAX.
ESD SYMBOL FOR PIN NO. 1
24X .010 ± .002
.975 MAX.
1.275 MAX.
NON-ACCUMULATIVE
24X .015 ±.003
2X 1.100
24X .072 ± .007
2X .500 MIN.
2X .085 REF.
▀
PART NUMBER GENERATION
SERIES
Output type and
supply voltage
TEMPERATURE RANGE (°C)/ Max. Overall
Stability/ Min. Frequency Pulling
and Voltage Control Range
Level
FREQUENCY
(MHz)
4: SINE WAVE +3dBm ..5V N: 0.....+50°C
±25 ppm ±50 ppm Vc=0.5..4.5V
E: Eng. Model 10……..350
5: SINE WAVE +7dBm ….12V P: 0.....+70°C
±35 ppm ±70 ppm Vc=0.5..6.0V
M: Flight Model
6: SINE WAVE +7dBm ..15V Q: 20…+70°C
±40 ppm ±80 ppm Vc=0.5..6.0V
R: 40…+85°C
±45 ppm ±90 ppm Vc=0.5..6.0V
U: -55.+125°C ±65 ppm ±130 ppm Vc=0.5..6.0V
QTV71:
24 Pin
Flat Pack
(See note 1 below)
1. Variations from standard specification are available, please contact factory.
EXAMPLE:
QTV715URM-100.000000 would be a Flight Model version HF VCXO, 24 pin SMD flat pack, sine-wave 12 volts, overall
frequency stability (Overall Frequency stability (including operating temperature, ±5% Load Change, ±5% Supply
Voltage change, 10 year aging, and radiation) ±45 ppm over -40…+85°C, @ 50 MHz with frequency pulling range from
minimum of 90 ppm below center frequency at 0.5V to a minimum of 90 ppm above center frequency at 6V.
QTV715URE-100.000000
would be a Engineering Model version HF VCXO, 24 pin SMD flat pack, sine-wave 12 volts,
overall frequency stability (including operating temperature, ±5% Load Change, ±5% Supply Voltage change, 10 year
aging, and radiation)) ±45 ppm over -40…+85°C, @ 50 MHz with frequency pulling range from minimum of 90 ppm below
center frequency at 0.5V to a minimum of 90 ppm above center frequency at 6V.
FIGURE 1 INTERFACE CONTROL DRAWING
24 pin Flat-Pack
PIN NO. DESIGNATION
1 Control Voltage
2 - 11 NC
12 Ground/Case
13 RF Output
14 - 23 NC
24 Supply Voltage
NOTES:
•
Dimensions are in inches.
•
Lead numbers are for reference only and
are not marked on the unit.
•
A triangle symbol is marked on the corner of
the package to indicate Pin 1
•
All pins with NC function may not be
connected as external tie or connections
(Pins may be connected internally).