Q-Tech QT6T w__Gate - Manual (Page 2)

MIL-PRF-55310/17F
2
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerances are ±.005 (0.13 mm) for three place decimals and ±.02 (0.5 mm) for
two place decimals.
4. All pins with NC function may be connected internally and are not to be used as external tie points or
connections.
5. Color dot or square corner shall be used to indicate pin number 1.
6. ESD indicator, open triangle, shall be marked anywhere on the top of the oscillator.
FIGURE 1. Dimensions and configuration - Continued.
Ltr Inches mm
Min Max Min Max
A --- .887 --- 22.53
B --- .44 --- 11.2
C --- .27 --- 6.8
D --- .54 --- 13.7
E .145 .155 3.68 3.94
F .295 .305 7.49 7.75
G .295 .305 7.49 7.75
H .595 .605 15.11 15.37
J --- .20 --- 5.1
K .20 --- 5.1 ---
L .016 .020 0.41 0.51
M .095 .105 2.41 2.67