Pro Series 51082 51 Receiver - Manual

Installation Instructions
Kia Sorento
Part Numbers:
51082
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 19mm
Drill Bits: None
Rev. A 10-9-07 51082N Sheet 1 of 3 z 2007 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51082F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: SUV7
Form: F205 Rev A 5-6-05
Tighten all M12 X 1.50 CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
Conical Toothed Washer Qty. (4) 2 M12 X 1.50 X 40mm CL 10.9 Hex Bolt Qty. (4) 1
1. Raise receiver over exhaust and into position between vehicle frame rails.
2. Install M12 X 1.50 Hex bolts and conical toothed washers into existing weldnuts.
500 (227 Kg) 5000 (2268 Kg)
Weight Carrying
Ball Mount
500 (227 Kg) 5000 (2268 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Frame Rail
Frame Rail
Exhaust
Spare tire may need to be lowered for installation.
Fascia