Pro Series 51033 51 Receiver - Manual

Installation Instructions
Ford Explorer
Part Numbers:
51033
44100
Equipment Required:
Wrenches: 3/4, 15/16, 15mm, 18mm & 21mm
Drill Bits: None
1
Rev. A 6-27-06 N44100 Sheet 1 of 1 z 2002, 2006 Cequent Towing Products
Hex Nut 1/2-13 Qty. (2) 8 Hex Nut 5/8-11 Qty. (2) 4
Conical Washer 1/2 Qty. (2) 7 Lock Washer 5/8 Qty. (2) 3
Block Qty. (2) 6 Flat Washer 5/8 Qty. (2) 2
Carriage Bolt 1/2-13 X 2.00 Qty. (2) 5 Hex Bolt 5/8-11 X 2.00 Qty. (2) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: F44100
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg) 5000 (2270 Kg)
Weight Carrying
Ball Mount
600 (272 Kg) 6000 (2724 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV1, SUV2
2
3
4
7
8
5
6
PRE-1997
1. Hold hitch up to the frame and align 5/8” holes in the side of the frame. Using the 1/2” holes in the flange mark the frame and drill 1/2”
holes.
2. Install 5/8” bolt, flat washer, lock washer, and nut in forward holes. Install 1/2” bolt through bolt plate and insert through the frame
and install 1/2” conical washer and nut.
3. Torque 5/8” nuts to 100 LB-FT. (136 N*M).
Torque 1/2” nuts to 75 LB-FT. (102 N*M).
1997-CURRENT
NOTE: Sport versions will need to remove the tow hook to install the hitch.
1. Hold hitch up to the frame and install 5/8” bolt, flat washer, lock washer, and nut in forward holes in the side of the frame. Install 1/2”
bolt through bolt plate and insert through the frame and install 1/2” conical washer and nut. See diagram on the other side.
2. Torque 5/8” nuts to 100 LB-FT. (136 N*M).
Torque 1/2” nuts to 75 LB-FT. (102 N*M).
SERIES 51®
Form: F205 Rev A 5-6-05