Pro Series 44026 51 Receiver User Manual

Installation instructions, All ford pickup, Series 51

Installation Instructions

All Ford Pickup

(Except Ranger & Flare Side Pickup with

Fiberglass Rear Valence Panel)

Part Numbers:

44026

51009

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 3/4, 7/8

Drill Bits: 1/2”

Frame rail

Note: Due to vehicle variation, it may be necessary to adjust Step Bumper upward.
1.

Remove all but a thin layer of undercoating from attaching surfaces.

Position hitch over rivets on both frame rails, making sure the hitch is centered.

Note: Make sure rearmost attachment will allow block to sit flat on inside of frame rail, and pushed up against the crossmember.
3. Using the hitch as a template, drill three (3) 1/2” holes into the bottom of each frame rail.
4. Install all fasteners as shown above, placing blocks inside vehicle frame as shown.

Rev. A

6-27-06

N51009

Sheet 1 of 1

2001, 2002, 2006 Cequent Towing Products

Flat Washer 1/2

Qty. (6)

Hex Nut 1/2-13

Qty. (6)

Block

Qty. (6)

Lock Washer 1/2

Qty. (6)

Hex Bolt 1/2-13 X 1.75

Qty. (6)

Tighten all 1/2-13 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 51009-051

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

500 (227 Kg)

5000 (2270 Kg)

Weight Carrying

Ball Mount

1000 (454 Kg)

10,000 (4540 Kg)

Weight Distributing

Max Tongue

WT (LB)

Max Gross

Trailer WT (LB)

Hitch type

Wiring Access Location: PC1, PC2

Vehicle Crossmember

3
5

Step Bumper

Fasteners typical both sides.

SERIES 51®

Form: F205 Rev A 5-6-05