Pro Series 44101 51 Receiver - Manual

Installation Instructions
Ford Ranger
Mazda B2300, B3000, & B4000
Relocation of spare tire bracket
is not required
Part Numbers:
44101
51032
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm, 19mm, 3/4, 7/8
Drill Bits: 1/2”
Fasteners typical both sides
1. For vehicles with step bumper, remove rearmost bumper bracket bolt and j-nut (both sides).
2. Position hitch on vehicle, sandwiching bumper bracket (if present) between hitch and vehicle frame, install rearmost fasteners.
3. Using hitch as template drill two (2) 1/2 holes into frame at forward end of hitch.
Note: On some models holes may already exist.
4. Install remaining fasteners as shown. For vehicles with step bumper, place block (Item 5) between frame and side brackets at
forward attachment, as shown.
Rev. A 6-27-06 N51032 Sheet 1 of 1 z 2001, 2002, 2006 Cequent Towing Products
Lock Washer 1/2 Qty. (4) 3
Block .19 X 1.00 X 2.00 Qty. (2) 5 Block .25 X 1.00 X 2.00 Qty. (4) 2
Hex Nut 1/2-13 Qty. (4) 4 Carriage Bolt 1/2-13 X 1.75 Qty. (4) 1
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 01131-023
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
300 (136 Kg) 3500 (1589 Kg)
Weight Carrying
Ball Mount
500 (227 Kg) 5000 (2270 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PC1, PC2
Bumper
Frame rail
Bumper bracket
Existing bumper bracket
fasteners rearmost to be
removed
97 and Prior Models
Note: 19mm open end style
wrench must be purchased to
allow removal of spare tire after
hitch installation,
1
2
5
3
4
Place between frame and hitch if
vehicle is equipped with step bumper
SERIES 51®
Form: F205 Rev A 5-6-05