Pro Series 97085 51 Receiver - Manual (Page 2)

COMPASS
Installation Instructions
Jeep Compass*, inc. Rallye Package
Jeep Patriot*, inc. optional tow hook
Part Numbers:
51085
97085
z 2011, 2012 Cequent Performance Products Sheet 2 of 6 51085N 07/24/12 Rev. F
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05
Note 2.
Compass Rallye Package
It is necessary to trim bumper
fascia. Obtain vehicle owners
approval for cutting plastic fascia
before installing hitch!
See diagram.
COMPASS
Rear view of Rallye showing
section of fascia to trim out
Cut up to cross hatch pattern in fascia
Shown with hitch in place.
Figure 2
Jeep Compass Rallye Model
*2011 and Later Jeep Patriot and Compass
models require fascia trimming for hitch
installation. Obtain vehicle owner approval
before cutting.
6- 5/8” (168mm)
1- 1/2” (38mm)
3” (76mm)
Center Line of
Vehicle
Fascia Cut Line
Fascia Tabs
Fascia Tabs
Figure 3
Fascia Trimming Diagram for
2011 & Later Jeep Patriot and Compass Models
Ref 2”(51mm) **
Figure 4
** X (from ground to bottom of frame) must be
measured to double check placement of cut. X-5
inches is the distance measured from the ground
to the top of the fascia cut.
Frame
Ground