Pro Series 51206 51 Receiver - Manual

Installation Instructions
Hyundai Santa Fe
Kia Sorento
Part Numbers:
51206
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 16mm
Drill Bits: None
Fastener Kit: 51206F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 5000 (2270 Kg.) 500 (227 Kg.)
Weight Carrying
Ball Mount
3500 (1589 Kg.) 350 (159 Kg.)
Wiring Access Location: Santa Fe: SUV3, SUV4
Sorento: SUV7
Frame Rail
Exhaust
Weldnuts in Vehicle
Frame Rail-Typical
Fascia
1. Raise car on ramps, hoist, or jack stands.
2. Raise hitch into position, installing fasteners as shown into existing weldnuts in vehicle frame.
z 2011 Cequent Performance Products, Inc. Sheet 1 of 3 51206N 11-29-11 Rev. A
1 1 1 1 Qty. (4) Hex Bolt – M10 x 1.25 x 30mm 2 2 2 2 Qty. (4) Conical Toothed Washer – 7/16”
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 59 Lb.-Ft. (80 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Form: F205 Rev A 5-6-05
Fasteners Typical
Both Sides
12 12 12 12