Billet Specialties Premium Tru Trac Serpentine System - FE Ford - Manual (Page 8)

www.billetspecialties.com
15
www.billetspecialties.com
Figure 9: Install Idler Pulleys
Apply anti seize to the three 3/8-16 x 1-3/4” 12 pt ARP cap screws.
Install the first pulley by threading the 12 pt ARP cap screw through the pulley
cover, pulley and boss into the bridge bracket, tighten firmly (46 ft/lbs).
Follow by installing the next two pulleys as shown.
Figure 10: Install Tensioner Pulley & Belt
Apply anti seize to one 3/8-16 x 3/4” 12pt ARP
cap screw.
Route serpentine belt as shown below; minus
tensioner.
[A] Place a 5/8” box end wrench on tensioner.
[B] Align belt onto pulley and pull up until tensioner pulley slips onto tensioner shaft.
[C] Slowly return wrench to starting position to apply tension to belt, remove
wrench and install the 3/8-16 x 3/4" ARP 12pt. bolt with thrust washer onto pulley,
tighten firmly. (46 ft/lbs)
With Power Steering Without Power Steering
[A] [B]
[C]