Billet Specialties Premium Tru Trac Serpentine System - FE Ford User Manual
Page 5

www.billetspecialties.com
9
www.billetspecialties.com
Figure 3: Install Power Steering Pump Bracket
For kits without power steering continue to Figure 4.
Apply anti seize to two 5/16-18 x 1” socket head cap screws.
Place power steering bracket behind alternator bracket as shown, thread the
5/16–18 x 1” socket head cap screws through the power steering bracket and into
the alternator bracket, tighten firmly (26ft/lb).
Figure 4: Install Tensioner Bracket & Bridge Bracket
Apply anti seize to three 3/8-16 x 1-3/4” flat head cap screws and one
3/8-16 x 2-1/2” flat head cap screw.
[A,B] On the passenger side, thread two 3/8-16 x 1-3/4” flat head cap screws
through the bridge bracket and tensioner bracket as shown; aligning with bosses
on water pump and finger tighten. [C] Thread the 3/8-16 x 2-1/2" flat head cap
screw through the bridge bracket using the hole farthest from the water pump.
[D] On the driver side, thread the remaining 3/8-16 x 1-3/4” flat head cap screw
through the top hole in the bridge bracket and through the 13/16” spacer and
into the water pump boss as shown, and finger tighten.
[A]
[B]
[C]
[D]
3/8-16 x 1-3/4" Flat Head Cap Screw
3/8-16 x 2-1/2" Flat Head Cap Screw