Billet Specialties Premium Tru Trac Serpentine System - FE Ford User Manual

Page 4

www.billetspecialties.com

Figure 1: Prep Block & Install Water Pump

[A] Disconnect battery; remove all existing accessory drive brackets and
components from motor. Remove water pump, scrape away any existing gasket
material with a gasket scraper and dress surface with a Scotch Brite® pad.

Clean and prep water pump threads on engine block, use a 3/8-16 thread chaser
if necessary. Thread chasers are available at your local auto parts store or tool
dealer and are different from a thread cutting tool.

[B] Install brass heater fitting (or plug) and bypass fitting into water pump (included
with pump). Install manifold to water pump bypass hose.

[C] Apply RTV sealer to bolts provided with water pump. Coat both sides of water
pump gasket with Permatex Hylomar® gasket dressing. Install water pump to
engine block with hardware included with pump. Tighten to OEM specs.

Figure 2: Install Alternator Bracket To Water Pump

Apply anti seize to one 3/8-16 x 2” hex head cap screw and one 3/8-16 x 3/4”
socket head cap screw.

[A] Place alternator bracket on driver side of water pump as shown. [B] Thread the
3/8-16 x 2” hex head cap screw with a 3/8” washer through the back of the
bracket and into the water pump, finger tighten.

[C] Swing bracket into position by aligning the front bracket mount hole with the
water pump boss. Insert the 3/8-16 x 3/4” socket head cap screw through bracket
and into water pump boss. Tighten both fasteners firmly at this time. (46ft/lbs.)

[A]

[B]

[C]

[B]

[C]

[A]