Billet Specialties Premium Tru Trac Serpentine System - FE Ford - Manual (Page 10)

19
www.billetspecialties.com
FIGURE 14: Install Compressor Manifold
If you are going to be installing your air conditioning hoses and
charging the system at this time, remove the plate on top of the
compressor body and apply anti seize to the two 8mm-1.25 x 25mm socket head
cap screws.
Install compressor manifold onto compressor with two 8mm-1.25 x 25mm socket
head cap screws and tighten firmly (13ft/lbs).
Install hoses; connect clutch wire and charge system.
IMPORTANT
• If you are NOT installing hoses and charging the system at this time, place compressor
manifold and hardware in a safe place and leave cover plate on compressor at this time.
• Do not connect clutch wire or apply power to clutch wire without the hoses connected
and system charged – Serious damage will occur to compressor.
Compressor Oil
Although the compressor is supplied with oil, the level may not be correct for the entire
system. Consult the instruction manual of the air conditioning unit for proper levels and
system charging procedures.
FIGURE 15: Install Tensioner Pulley & Belt
Apply anti seize to one 3/8-16 x 3/4” ARP 12pt cap screw.
Route serpentine belt as shown below; minus tensioner.
[A,B,C] Place a 5/8” box end wrench on tensioner. Align belt onto pulley and push
down until tensioner pulley slips onto tensioner shaft.
[D] Slowly return wrench to starting position to apply tension to belt,
remove wrench and install the 3/8-16 x 3/4" ARP 12pt. bolt with thrust washer onto
pulley, tighten firmly. (46 ft/lbs)
With Power Steering Without Power Steering
[B]
[A]
[C]
[D]