Ocean Optics OTS - Manual (Page 22)

B: Specifications
9. Replace the bulb and reconnect the wires to the connection block.
10. Slide the lamp into the housing and secure the housing with the bottom screw.
11. Slide the electronics board back into the light source, taking particular care to ensure that the
wires do not come into contact with the fan blades.
12. Reconnect the power connection and 15-pin D-Sub connector, taking care not to change the
setting on the toggle switches on top of the unit. (The Power switch should be set to “ON” and
the Shutter switch should be set to “TTL”).
13. Secure the light source to the OTS using the 3 hex screws at the top of the instrument.
16 OTS-00000-000-02-1008