Ocean Optics HR4000CG-UV-NIR - Manual (Page 34)

B: HR4000 Specifications
• The mating connector is Part Number P50–030S–TGF.
• Mating the two components requires two 1.27 mm (50 mil) flat ribbon cables (3M 3365 Series is
recommended).
If you are customizing your HR4000 Spectrometer system or configuring External Triggering, you may
need these part numbers to complete your setup.
HR4000 15-Pin Accessory Cable Pinout
Pin # Description Pin # Description
1 Single_strobe 9 GPIO-9
2 ContStrobe 10 GND_SIGNAL
3 V5_SW 11 SDA
4 ExtTrigIn 12 SCL
5 ExtTrigIn 13 LampEnable
6 GPIO-8 14 A_IN
7 A_OUT 15 GPIO-7
8 ExtTrigIn
26 210-00000-000-02-0908