Ocean Optics NeoFox Engineering Note User Manual
Page 22
NeoFox Communication Interfaces
22 013-20000-010-04-201211
Multi Point SP B0
Float
n/a
268
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP B1
Float
n/a
272
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP B2
Float
n/a
276
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP C0
Float
n/a
280
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP C1
Float
n/a
284
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP C2
Float
n/a
288
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP T0
Float
n/a
292
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.