Ocean Optics NeoFox Engineering Note User Manual
Page 21
NeoFox Communication Interfaces
013-20000-010-04-201211 21
Multi Point Orig C1
Float
n/a
207
236
NEOFOX_CAL_MULTI_C1
DeviceSetParameterFloat
DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
engineering note and the
for more information about this parameter.
Multi Point Orig C2
Float
n/a
208
240
NEOFOX_CAL_MULTI_C2
DeviceSetParameterFloat
DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
engineering note and the
for more information about this parameter.
Multi Point Orig T0
Float
n/a
209
244
NEOFOX_CAL_MULTI_T0
DeviceSetParameterFloat
DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
engineering note and the
for more information about this parameter.
Multi Point OrigT1
Float
n/a
210
248
NEOFOX_CAL_MULTI_T1
DeviceSetParameterFloat
DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the calibration methods app note and the
for more
information about this parameter.
Multi Point Orig T2
Float
n/a
211
252
NEOFOX_CAL_MULTI_T2
DeviceSetParameterFloat
DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
engineering note and the
for more information about this parameter.
Multi Point SP A0
Float
n/a
256
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP A1
Float
n/a
260
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.
Multi Point SP A2
Float
n/a
264
n/a
n/a
n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
engineering note and the
for more information about this parameter.