Ocean Optics DH-2000-CAL - Manual (Page 14)

2: DH-2000-CAL Specifications
6 000-10000-030-02-1209
Front Panel
Component Description
Deuterium On/Off
Press to turn the Deuterium lamp on or off. There is a delay of 20 seconds before
the Deuterium lamp is illuminated. You must allow the bulb to warm up for 20
minutes to receive accurate data from the lamp.
LED lights green upon successful illumination, or red to indicate lamp malfunction.
Power LED Indicates the power state of the DH-2000-CAL.
Mechanical Protection –
Optical Output
Covered to protect users from unintentionally looking directly at the beam of light.
Connect the fiber cable to the DH-2000-CAL BEFORE turning the lamp on to avoid
unnecessary exposure to UV radiation.
Always wear proper eye protection when using the DH-2000-CAL lamp.
Halogen On/Off
Press to turn the Halogen lamp on or off. Requires a warm-up time of 20 seconds
before the Halogen lamp is illuminated. You must allow the bulb to warm up for 20
minutes to receive accurate data from the lamp.
LED lights green upon successful illumination, or red to indicate lamp malfunction.
Deuterium On/Off
Power LED
Mechanical Protection –SMA
Connector
Tungsten-Halogen
On/Off