Factory Direct Hardware LCN 9531 - Manual (Page 14)

Page 14 of 14 740100-00(5)
7.1. Remove all tools, installation equipment, and debris from the vicinity of the door.
7.2. Install all safety, traffic control, and instruction decals on the door as required by the
latest revision of ANSI/BHMA A156.19. This is very important! Failure to do this
leaves the installer LIABLE for any accident that might occur. This must be done!
7.3. Verbally instruct the owner or person in charge of the proper operation of the door.
7.4. Instruct the owner or person in charge to routinely inspect the door for the following:
• Visible damage
• Developing problems
• Minor preventive maintenance
7.5. Instruct the owner or person in charge who and where to call for service when required.
7. RELEASE FOR SERVICE
Make sure to install all safety, traffic control,
and instruction decals on the door as required.
IMPORTANT !
If control box does not function and the error message Er## flashes on the control
box Setting and Value displays, turn AC power off and on to reset the control box.
The following are common errors and suggested fixes:
ER 06: Master motor problem - verify master motor cable is connected to motor.
ER 14: Companion door added to a setup that was already sized - turn AC
power off, then on and resize with both doors connected.
If problem cannot be corrected by using suggested fixes, contact 1-800-526-2400.
6.2.
6. TROUBLESHOOTING (continued)