beautypg.com

Factory Direct Hardware Hansgrohe 10406001 Axor Starck X User Manual

Page 2

background image

2

Starck X Free-Standing Tub Filler

10406001

Technical Specification

Maximum incoming water pressure

145 psi

Recommended water pressure

14.5 - 72 psi

Recommended incoming hot water temp 120

o

F - 140

o

F*

Spout flow rate @ 45 psi

5.75 gpm

Handshower flow rate

2.5 gpm

This unit is not anti-scald. If anti-scald capability is desired, or is required by local

plumbing codes, install this unit in combination with Hansgrohe remote pressure balance

valve 13418181 or similar unit.

Backflow prevention is provided by a check valve in the handshower outlet, and an

automatically re-setting diverter.

*Know and follow all applicable plumbing codes when setting the temperature on the water heater.

Installation Considerations

Rough-in 10452181 must be installed, and the finished floor complete before this

tub filler can be installed.

Flush the hot and cold supplies for at least 5 minutes prior to installing the tub filler.

Damage to the cartridge caused by debris is not covered under the Hansgrohe

warranty.