dbx ZonePRO InstallGuide - Manual (Page 12)

6
ZonePRO TM
3.
Wait approximately 10 seconds after the main ZonePRO
Designer window has appeared. If a ZonePRO icon appears in
the upper left hand corner of the window, you are online with
the processor and ready to begin programming. Simply double
left click on the ZonePRO icon to open the Program Screen and
begin programming. If the icon does not automatically appear,
proceed with these instructions.
4.
Go into Window’s Device Manager > Ports. Take note of your
COM port’s assigned COM number (shown in parenthesis). If
you do not see your COM port here, you may need to reinstall
the drivers for your COM port peripheral.
5.
Double left click on the connected COM port listed in the
previous step. Click the Port Settings tab and set your COM
port settings as shown to the right then click the OK button.
6.
Go back into ZonePRO Designer and go to Network >
Properties.
ZonePRO Designer GUI
Section 2