dbx DriveRack PA2 - Manual (Page 58)

54
®
3-Way Application
This application is suited for systems using bi-ampable main speakers along with subs. In this type of application, the PA2
will split the signal into three frequency bands and send all the low frequencies out the LOW outputs to the subs, all the mid
frequencies out the MID outputs to the woofers in the mains, and all the high frequencies out the HIGH outputs to the high
frequency drivers in the mains. When configuring the PA2 for this type of application, the LOW, MID, and HIGH outputs will be
enabled.
Application Notes:
• Make sure your mixer and amplifiers (or powered speakers) are turned off before making connections.
• Make connections as described in ‘Making Connections’ on page 8 then apply power to the system according to
the instructions described in ‘Applying Power’ on page 10.
• Run the Setup Wizard and select the MONO input option if connecting your mixer to the PA2 via a single connection, or
select the STEREO input option if connecting the mixer to the PA2 via a left/right stereo connection.
• In the Setup Wizard, select your main and sub speakers from the list. When prompted, select the 2-WAY main speaker
configuration option. If your speakers are not listed in the PA2, use the DriveRack PA2 control app to check the online
database to see if your speaker tunings have been added. If you can’t find speaker tunings for your speakers, select the
NOT LISTED option from the tuning list.
120V 50/60Hz
R
L
R
L
R
L
R
L
R
L
R
L
To Power
Outlet
High Amp
Mid Amp
Low Amp
Mixer
or or
Windows ® or Mac ®
Computer
iOS ® or Android ®
Tablet
iOS ® or Android ®
Phone
R L/Mono
Left Sub Speaker Right Sub Speaker
Left Main Speaker Right Main Speaker
or
Wireless Router
LEgEND
Analog Audio Connections
Omit Connection For Mono Systems Ethernet Connection
IEC Power Cord Left Channel L
Right Channel R Wi-Fi Signal