R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 Stepless - Manual (Page 37)

LM10 STEPLESS I&M MANUAL/EN/11.30.2010
37/99
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
7.5.7 Parameter adjustments
7.5.7.1 The display panel
Figure 15. Display Panel
The display panel is used for :
Displaying the drive identification, electrical values,
operating or fault parameters
Altering the parameter settings
START
STOP
enter
reset
Drive status indications:
Motor is running, blinks when ramping down.
Direction of motor rotation.
Motor is not running.
Power is on. In case of a fault, the symbol will not light up.
Drive is running outside of certain limit.
Fault is active
Control place indications:
I/O term I/O-terminals are the selected control place
Keypad Keypad is the selected control place (not used)
Bus/Comm Control through Profibus is selected (not used)
Button description
Browse the main menu and the pages of submenus
Edit values
Move in menu
Move cursor
Enter and exit edit mode
START
Start button
STOP
Stop button
Active faults reset
Fault history reset
Confirmation of selections
enter
reset