Prokit's Industries MT-7025 - Manual (Page 10)

RJ-11, Alligator connector or 8P8CR J45 patch cord to
connect the tested cable according to the tested cable type.
 Slide “Power and function switch” to “SCAN” position,
transmitter will transmit dual frequency tone. If you want to
change the dual frequency to single, press “Function
changed button” shortly for frequency change.
 Please press and hold the “Cable finding tested button”,
put tested probe as close as possible to numerous cable or
wall that has cable inside, the speaker will sound when the
tested probe near the tested cable (Signal indicator also
lights up), if testing switching equipment, you will find
receiver sounded when close 2 or 3 wire, need to find the
clearest sounded one by receiver.
 It is probable tone signal interfere by telecom switching
equipment signal when perform cable finding test that will
effect testing result, you can turn off telecom switching
equipment power if necessary.
***Telecom cable open/short testing
9
 Slide “Power and function switch” to “TEST” position,
press test button and hold 2 seconds, the “VERIFY” LED will
change from flash to light up.