Prokit's Industries MT-8002 - Manual (Page 11)

11
TEL Mode
The MT-8002 can be used as a telephone when it is switched to TEL mode and
is connected to a working analog Tel. line. The MT-8002 works like a normal tele-
phone. When off-hook, the MT-8002 is used to perform its main purpose, which is
to test the proper operation of analog voice telephone lines.
• On-hook
• Pick up call
When receiving a FSK or DTMF call, the Caller ID and the calling time will
display on LCD. The MT-8002 will also add the number to the incoming call
list and give it a corresponding order in the list. If the call is from a FSK sys-
tem, the MT-8002 will update the month, date and time setting of system by
the information provide by FSK signal. If the call is come from DTMF system,
MT-8002 will show the system date and time. LCD will also displays the cor-
responding order of the receiving call in the incoming call list. If the number
is not in the incoming call list, the LCD will indicate it is a new number.
• Last Number Redial
If a call is not successful and you wish to redial the same number, just press
the LNR button.
The last number redial function is available in either the Pulse or Tone Mode.
The redial memory has a 32-digit capacity.
• Memory Dialing
The MT-8002 Telecom test set allows the user to dial preprogrammed
numbers in either Tone or Pulse mode. If dialing in Pulse mode and the
stored number contains an asterisk ( ) or pound (#) symbol, the digits will be
ignored.
To activate Memory Dialing:
1. Connect the test set to a working telephone line.
2. Press the RCL key.
3. Press the key of memory location (M1, 0~9, and #)
4. To set a number to the memory, please refer to Memory function
description.
• Call list
The MT-8002 retains the 16 outgoing and 62 incoming phone numbers in its
CALL LIST. Incoming numbers are recorded when Caller ID messages are
received. Outgoing numbers are recorded when you dialing a number.
The most recently received number is always put on top of the list and the
other numbers are pushed down. The Call List is available for viewing when
the test set is on-hook or off-hook. You can view and dial from the Call List.
To use the Call List:
1. Press or to enter the incoming calling list, press the OUT key to
enter outgoing call list.
2. Use the or key to view numbers in the Call ID list. Use key to view
the number in dialing out list.