Prokit's Industries MT-8002 - Manual (Page 10)

10
OPERATION
MT-8002 Telecom test set has three modes of operation: TEL mode, ADSL mode
and CBALE mode. Before introduce operations of the three mode, we should
know more about the parameter setting.
Parameter Setting
With MT-8002 on hook, press STO key will enter the setting mode. The “SET 1
DATE” shows on LCD. User can switch the setting item by press / key then
press STO key to enter the setting. If user wants change the setting press the
/ key again. When the correct setting is appears, press STO key to move to
next setting. During the setting press DEL will quit from the setting mode.
• Date and time
If the “SET 1 DATE” display on LCD, press STO key to enter the Date and Time
setting. The number of year will flash, press / key to adjust the value of
year. Press STO key again will move to the month setting. Use the same way
to change the value of month then press STO to move to the date and time
setting. When all the value of date and time are correct, press STO key to move
to “SET 2 ACODE”.
• Area code
When the “SET 2 ACODE” is displayed on LCD, press STO key to enter the
area code setting item. LCD will show “ACODE-----“. The first digit of area code
will flash, press / key to change the value. Press STO key to move to the
nest digit. If all the digits are set, press STO key to enter “SET 3 FLASH”.
• Pause Duration
If the “SET 3 FLASH” is displayed on LCD, press STO key to enter the Pause
Duration setting. LCD will show “FLASH 1 600”. It means the default pause du-
ration time is 600 ms, Change the value by / keys then press STO to move
to the “SET 4 LCD”.
• LCD light adjust
When the “SET 4 LCD” is displayed on LCD, press STO key to enter the LCD
brightness adjust mode. There are 5 LCD brightness level can be selected.
Press / key to change the level then press STO to jump to “SET 5 ALAR” or
press DEL to quit.
CAUTION:
The “SET 5 ALAR” is not used by MT-8002, we suggest users do not to
change the value in “SET 5 ALAR” setting. In this setting item press STO
to jump to “SET 6 IPP” or press DEL to quit.
• Dialing mode
If the “SET 6 IPP” is displayed on LCD, press STO key to enter the dial mode
setting. The IPP ON/OFF will show on LCD, use / key to swap between
them. If “IPP OFF” is selected, the dialing mode is tone. Otherwise, the dialing
mode is pulse.