Newport Brass 3-1771 Victoria - Manual

Installation Instructions
In- wall Lavatory Kit
Models 1-532T
2001 CARNEGIE AVE, SANTA ANA CA 92705
(949) 417-5207
WWW.NEWPORTBRASS.COM
05/02/2013 NWP-1-532T
We Recommend Installation by a Professional Plumbing Contractor
Note: Use plumbers tape or equivalent to seal all threaded port joints.
Warning: To prevent severe damage to valve body, any solder/braze process must be per-
formed a min. of 4" from ports.
Important: : REMOVE CARTRIDGE FROM VALVE BODY(1) PRIOR TO APPLY-
ING ANY HEAT/FLAME.
1. Secure valve BODY (1) to cross BRACE (2) using suitable SCREW (3), not included.
2. Check the horizontal and vertical level of valve BODY (1) by placing bubble level on STEMS
(4, 5). Make any necessary adjustments.
3. Utilizing a 1/2"copper supply pipe and 1/2" Socket End x 1/2"NPT Male Pipe Adapter to
sweat water supply line to inlets of Valve BODY(1), (blue STEM (4) is cold, red STEM (5) is
hot). If sweating supplies are directly connected to valve inlets, remove cartridges during this
process.
Note : If cartridges are removed during installation, re-torque to factory specification
of 14-16 ft-lbs.
4. Adjust stiffness of stem rotation by tightening or loosening TORQUE NUT. Check stiffness
by placing lever handle in horizontal position onto cartidge stem. Handle should not rotate
under its own weight.
(Note: Water supply to valve should still be off; water pressure may affect the stiffness of
stem.)
5. With STEM (4,5) in closed position, turn on water supply, pressurize system and check for
leaks.
NOTE: The following step may only be performed after finished wall surface has been com-
pleted.
6a. 1/2 NPT Spout configuration - Installer shall use appropriately sized 1/2 NPT nipple
(not included) to attach spout to valve body. Thread sealant shall be appplied to both ends of
nipple and be tightened into valve body. Tighten spout (and base ring if supplied) to nipple end
protruding from finish wall.