Newport Brass 30-28 - Manual

Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. See Figure 1.
Note: Hole locations should be level.
· 24" Single Towel Bar - 24 5/16"
· 30" Single Towel Bar - 30 5/16"
· Tissue Holder - 6 1/4"
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Fasten FLANGE (1) to finished wall using either WOOD/TOGGLE SCREWS (2). Place
ADAPTER POST (3) into FLANGE (1) at specified height of 2-5/16”. Secure
ADAPTER POST (3) in place with SETSCREW (4). See Figure 2.
5. Place ESCUTCHEON (5), BONNET (6) and NUT (7) over POST (3). See Figure 3.
6a.TOWEL BAR: Assemble TOWEL BAR (9) between END POST (6). Place END
POST (6) onto POST (3). Secure in place with SETSCREW (4). See Figure 4.
6b.TISSUE HOLDER: Place END POST (6) onto POST (3). Secure in place with
SETSCREWS (4). Place HOLDERS (8) between END POSTS (6). See Figure 5.
Towel Bar / Post Tissue Holder
Installation Instructions
Model No.
30-02, 30-03, 30-28
Fig. 1
6
4
Distance between
posts
3
Fig. 2
Fig. 3
Fig. 4
1
2
4
9
6
4
3
8
3
2-5/16
7
5 3
6
Fig. 5