Newport Brass 15-12 Towel Ring_Garment Hook - Manual

Towel Ring / Garment Hook
Installation Instructions
Model No.
15-09, 15-12
Recommended Installation by a Professional Contractor
1. Drill holes in wall at points marked using the appropriate drill size:
· Wood Screw (#10 x 1 3/4”) - use: 1/8" Drill
· Toggle Screw (10-24 x 3”) - use: 9/16" Drill
2. Loosen SETSCREW (4) in FLANGE (1) and remove POST (3). Fasten FLANGE (1) to
wall using either WOOD/TOGGLE SCREWS (2). (See Fig. 1)
Align FLANGE (1) so that upper flat is level.
3. Thread POST (3) onto FLANGE (1) Position POST (3) height to 2 5/16” from mounting
surface. Secure POST (3) into place by tightening SETSCREW (4). (See Fig. 1)
4. Thread ESCUTCHEON (5) onto FLANGE POST (3). (See Fig. 2)
5a. Towel Ring: Slide END POST (6) onto FLANGE POST (3) and secure into place
with SETSCREW (4). (See Fig. 3)
5b. Garment Hook: Slide END POST (6) onto FLANGE POST (3) and secure into
place with SETSCREW (4). (See Fig. 4)
Fig. 1
(949)417-5207
AMS-15-09 Santa Ana CA 92705 7/07/04
www.brasstech.com
Fig. 3 Fig. 4
6
4
4
3
2
Fig. 2
1
3
5
3
6
2 5/16”
3
4