Newport Brass 22-12 Towel Ring_Garment Hook - Manual

Towel Ring / Garment Hook
Installation Instructions
Model No.
22-09, 22-12
Recommended Installation by a Professional Contractor
1. Drill holes in wall at points marked using the appropriate drill size:
· Wood Screw (#10 x 1 3/4”) - use: 1/8" Drill
· Toggle Screw (10-24 x 3”) - use: 9/16" Drill
2. Loosen SETSCREW (4) in FLANGES (1) and remove POSTS (3). Fasten FLANGES (1) to
wall using either WOOD/TOGGLE SCREWS (2). (See Fig. 1)
Align the FLANGE (1) so that upper flat is level.
3. Thread POST (3) onto FLANGE (1). Postion POST (3) height to 2 3/16” from mounting
surface. Secure POSTS (3) into place by tightening SETSCREWS (4). (See Fig. 2)
4. Place ESCUTCHEON (5) over FLANGE POST (3). (See Fig. 3)
5a. Towel Ring: Slide END POST (6) onto FLANGE POST (3) and secure into place
with SETSCREW (4). (See Fig. 3)
5b. Garment Hook: Slide END POST (6) onto FLANGE POST (3) and secure into
place with SETSCREW (4). (See Fig. 4)
Fig. 1
(949)417-5207
AMS-22-09 Santa Ana CA 92705 6/08/04
www.brasstech.com
Fig. 3 Fig. 4
3
4
4
6
3
2
Fig. 2
1
2 3/16”
1
3
4
3
5
6