Newport Brass 3-1687 Virginia - Manual (Page 3)

Set screw
Bonnet**
Escutcheon**
Spout
Spout nipple
w/ o-rings
Quick connect
Deck flange
Valve
Threaded Deck Flange
Handle shower
Handle
** Optional item based on model selected
Figure 3
Set Screw
NWP1-548A 01/31/2011
Trim Installation
Note:
To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only.
(Cartridge Bonnet factory torque is 14-16 ft-lbs.)
1. Attach handle and diverter trim to valves. Any adjustments for rotational alignment must be made to the
valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet
to prevent damage to the surface finish.) Secure handles into place with setscrew.
2. Apply Teflon tape to spout nipple and install into base of spout. Slide spout nipple into quick connect deck
flange (re-grease if necessary). Make sure spout is flush with deck and secure into place with setscrew. See
Figure 3
3. Install decorative ring to threaded deck flange. Attach braided hose, from diverter, to the hand shower
decorative hose and assembly.
4. Turn on water supply, check for leaks and make any final adjustments required.