Newport Brass 2566 Skylar User Manual
Page 3
Trim Installation
1.Utilizing 3/4” copper pipe, make connections between spout, valves and water supply.
See Figure 3. Warning: To prevent severe damage to valve body, any solder/braze
process must be performed a min. of 4" from ports.
2.Place the O-RING (9) and ESCUTCHEON (11) onto STEM (12). Secure HANDLE (8) into
place by first engaging the STEM (12) and then threading MOUNTING NUT (7) onto car-
tridge. Any adjustments for rotational alignment must be made to the valve body, not to
the cartridge. Repeat on other side. See Figure 4. (Cartridge Bonnet factory torque is 14-
16 ft-lbs.)
3.Turn on water supply, and flush both valves until water is clear.
4.Check for leaks and make any final adjustments required.
Figure 3
Inlet for
hot
water
supply
Inlet for
cold water
supply
Figure 4
8
11
12
9
NWP-1-656
EN-2108
REV -
- 212 (2 pages)
- 941 (3 pages)
- 277-02 (2 pages)
- 12-27 (2 pages)
- 22-51 & 52 (3 pages)
- 120 Brasstech (1 page)
- 9451-1 (3 pages)
- 2540A Metro (3 pages)
- 22-28 (2 pages)
- 29-28 (1 page)
- 3-424 Kiara (2 pages)
- 280H (1 page)
- 7008X (4 pages)
- 283 (2 pages)
- 283-4 (2 pages)
- 3-1767 Victoria (4 pages)
- 2546 Metro (2 pages)
- 1-564 (1 page)
- 31-12 Towel Ring_Garment Hook (2 pages)
- 130 Brasstech (1 page)
- 29-52 (4 pages)
- 9452-1 (3 pages)
- 30-27 (2 pages)
- 104B (2 pages)
- 30-28 (2 pages)
- 280J (2 pages)
- 3-906 Kayan (4 pages)
- 281A (2 pages)
- 26-28 (2 pages)
- 281B (2 pages)
- 15-12 Towel Ring_Garment Hook (2 pages)
- 12-02 (1 page)
- 281C (2 pages)
- 29-30 (2 pages)
- 19-27 (2 pages)
- 39-28 (2 pages)
- 9901 (3 pages)
- 9453-1 (3 pages)
- 280M (2 pages)
- 2500-5503 (2 pages)
- 280A (2 pages)
- 22-12 Towel Ring_Garment Hook (2 pages)
- 1660 Astaire (4 pages)
- 281 (2 pages)