Newport Brass 1-677 - Manual (Page 3)

Trim Installation
Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rota-
tion only. The use of petroleum base plumbers putty on our products will nullify the warranty. We recom-
mend the use of clear silicone sealing materials. (Cartridge factory torque is set @ 14-16 ft-lbs.)
4. Apply plumbers tape to spout nipple and install into quick connect spout shank. Slide spout base onto spout
(re-grease if necessary). Make sure spout bottoms out onto quick connect spout and then secure in place with
setscrews.See Fig. 3.
5. Place escutcheon over valve stem. Secure handle assembly into place by first engaging the valve stem, then
position and holding the handle lever while rotating the bonnet. Any adjustments for rotational alignment must
be made to the valve body, not to the cartidge. See Fig 3.
6. Turn on water supply, check for leaks and make any final adjustments required.
Fig. 3
Spout nipple
w/ o-rings
Quick connect
spout shank
Spout
NWP-1-677
EN- 2406
REV -
2001 CARNEGIE AVE, SANTA ANA CA 92705
(949) 417-5207
WWW.NEWPORTBRASS.COM
01/09/2013
Lever
Escutcheon
Valve stem
Spout base
Set screw
Bonnet