Newport Brass 1-677 - Manual (Page 2)

Rough-in Valve Installation
Recommended Installation by a Professional Plumbing Contractor
Note: Use plumbers tape or equivalent to seal all threaded joints.
Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4"
from ports.
1. Install the quick connect spout shank through center hole of mounting surface. Secure with washer nut. See
Fig. 1.
2. Place washer nut on valve body. Insert body, (blue cold & red hot), through hole from below mounting sur-
face. See Fig. 1. Adjust and secure with additional nut so that the top of valve stem is at the correct height
from mounting surface.
3. Attach hot/cold valves to spout, utilizing ¾" copper pipe. See Fig. 3.
3/4” NPT
Finished Deck
Fig. 1
Washer Nut
1- 3/16”
Spout nipple to
be used with
trim installation
Fig. 2
Inlet for hot
water supply
Inlet for cold
water supply
NWP-1-677
EN-2406
REV -
1-1/4”
Quick connect
spout shank
1-1/4”
Valve body