KIA Magentis 2006 - Manual (Page 133)

WINDSHIELD
DEFROSTING AND
DEFOGGING (MANUAL
TYPE)
TO DEFOG INSIDE WIND-
SHIELD
1. Set the mode selection switch to the
or position.
When you select or position, the
system automatically turns on outside
(fresh) air mode.
2. Set the temperature control knob to
the desired position.
3. Set the fan speed control knob to any
desired speed except “0”.
For maximum defogging, set the fan
speed control knob to the “3” or “4”
position.
TO DEFROST OUTSIDE WIND-
SHIELD
1. Set the mode selection switch to the
position.
When you select position, the
system automatically turns on the
outside (fresh) air mode.
2. Set the temperature control knob to
the extreme right/hot position
3. Set the fan speed control knob to the
“3” or “4” position.
• For maximum defrosting, set the
temperature control knob to the
extreme right/hot position and the fan
speed control knob to the highest
speed.
• If warm air to the floor is desired
while defrosting or defogging, set the
mode selection knob to the
position.
• Before driving, clear all snow and ice
from the windshield, rear window,
outside rear view mirrors, and all side
windows.
• Clear all snow and ice from the hood
and the air inlet in the cowl grille to
improve heater and defroster
efficiency and to reduce the
probability of fogging on the inside
of the windshield.
DRIVING YOUR VEHICLE
4-54
1
2 3 4
0
2 3 1
MMSA4052
1
2 3 4
0
2 3 1
MMSA4052
MS-CNA-Eng 4(40~).QXD 7/25/2005 5:15 PM Page 54