Configuration setting, 1 mobile phone pairing, Expand – Sena Bluetooth EXPAND v1.0 User's Guide User Manual
Page 13

13
EXPAND
English
5. CONFIGURATION SETTING
You can set the configuration of the Sena Expand by
the voice menu instructions as below.
1. To enter the voice configuration menu, press and
hold the Center Button for 10 seconds until the
LED shows solid blue and you hear high tone
double beeps. You will also hear the voice prompt,
“Configuration menu”.
2. Press the (+) Button or (-) Button to navigate
between the menus. You will hear voice prompts
for each menu item as below.
3. You can enable / disable a feature or execute a
command by pressing the Center Button.
4. If you want to exit configuration immediately, press
and hold the (+) Button or (-) Button until you hear
the voice prompt, “Exit configuration”, then press
the Center Button.
The voice prompt for each menu item is as follows:
(1) Phone pairing
(6) Voice prompt
(2) Multipoint pairing
(7) Delete all pairings
(3) Phone selective pairing (8) Factory reset
(4) Media selective pairing (9) Exit configuration
(5) Speed dial
Phone pairing
Multipoint pairing
Voice prompt
Phone selective pairing
Delete all pairings
Media Selective pairing
Factory reset
Speed Dial
Exit configuration
5.1 Mobile Phone Pairing
Voice Prompt
“Phone pairing”
Factory Default
N/A
To go into mobile phone pairing mode, press the (+)
Button or the (-) Button until you hear the voice prompt,
“Phone pairing”. Please refer to section 6.1 for details
on mobile phone pairing. If you press the (+) or (-)
Button, you can exit from the phone pairing mode.