Fi g. 3.2 fi g. 3.1 – Peerless-AV SAX772PU - Installation User Manual

Page 8

8 of 41

ISSUED: 01-25-12 SHEET #: 095-9370-6 09-20-13

If you have any questions, please call Peerless customer care at 1-800-865-2112.

Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as shown
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not overtighten.
If screw cannot make three full turns into the display, select a longer length screw from the baffl ed fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not overtighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

3-1

3-2

DISPLAY

MULTI-WASHER

SCREW

fi g. 3.2

fi g. 3.1

SPACER

ADAPTER

BRACKET (B)

ADAPTER

BRACKET (B)