Peerless-AV ECMU-04-I-S - Installation - Manual (Page 5)

5 of 36 ISSUED: 06-22-10 SHEET #: 061-9055-6 01-15-11
Tighten bolts (T) on sides of ceiling plate assembly
just until they touch the ceiling clamp.
Tighten hex nuts (Y) until they touch the sides of
ceiling plate assembly.
Wrap the 5' wire rope (W) tightly around the beam
once as shown. Use two cable clips (X) to connect
the ends together as shown below.
Once cable clips have been attached, the excess
cable ends can be removed.
4 5
Safety Cable Installation
T
Y
W
X