Peerless-AV DS-VWC655-3X3 - Installation - Manual (Page 7)

7 of 13 ISSUED: 11-16-11 SHEET #: 125-9265-2 11-21-13
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112.
7
Attach three horizontal rails assemblies onto vertical supports ( A) using twenty-four 1/4-20 x 3.5" hex head screws
( J), 1/4" SAE washers (F) and 1/4-20 nylock nuts (K) as shown in detail 2. Make sure that horizontal rail
assemblies are level then tighten all 1/4-20 x 3.5" hex head screws ( J). Place two tube caps (R) into tops of vertical
supports ( A) as shown in detail 2. NOTE: horizontal rails must be secured using twenty-four 1/4-20 x 3.5” hex head
screws ( J).
A
F
K
J
Y
A
J
J
DETAIL 2
R
CABLE MANAGEMENT
8
Run display cables though top and bottom
openings in vertical supports ( A) as shown.
NOTE: Display cables can be covered using
18" mesh sleeve ( M) before securing.
Display cables can be secured to horizontal
rails assemblies using cable ties ( Q) as needed
through slots in horizontal rails ( Y).
Q
DISPLAY CABLES
M
Y
BOTTOM
OPENING
TOP
OPENING
A
Y
SLOT