Peerless-AV WL-ST660-200 - Installation User Manual

Page 9

9 of 14

ISSUED: 08-24-12 SHEET #: 180-9038-2 10-30-12

If you have any questions, please call Peerless customer care at 1-800-865-2112.

DISPLAY

MULTI-WASHER

SCREW

TILT BRACKET

(B or C)

fi g. 4.1

SPACER

Begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a shorter length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

4-1

Wireless Receiver Assembly and Power Module Assembly Setup

Remove the two #8 screws securing the cover of the wireless receiver assembly (G) as shown in detail 1. Open
the enclosure to expose the wireless receiver and IR receiver. Remove the M5 x 10mm phillips screws and open
the power module assembly (H) as shown in detail 2.

DETAIL 1

DETAIL 2

#8 SCREW

M5 X 10mm SCREWS