Peerless-AV CM60-S - Installation - Manual (Page 2)

2 of 30 ISSUED: 07-22-08 SHEET #: 120-9054-2 09-30-11
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity. See page 1.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with
the hardware included in this product as specified in the installation sheet. To mount this product to an alternative
supporting surface, contact Peerless customer care at 1-800-865-2112.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION HARDWARE REQUIRED
• Wood Stud Included
• Wood Beam Included
• Solid Concrete Included
• Cinder Block Included
• Brick Contact Qualifi ed Professional
• Other or unsure? Contact Qualifi ed Professional
Note: Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Interior Corner Wood Stud Walls ......................................................................................................................4
Installation to Exterior Corner Wood Stud Walls.....................................................................................................................5
Installation to Interior Concrete or Cinder Block Walls ...........................................................................................................6
Installation to Exterior Concrete or Cinder Block Walls ..........................................................................................................7
Attaching Interface Plate and Center Plate ....................................................................................................................... 8, 9
Installing Speaker Mounts ................................................................................................................................................... 10
Tools Needed for Assembly
• stud fi nder (edge-to-edge stud fi nder recommended)
• phillips screwdriver
• drill
• 5/32" drill bit for wood stud wall
• 5/16" drill bit for concrete wall
• level
Accessories
• ACC324(-S) - Shelving Unit for Corner Mount
• ACC930 - Fastener pack for speaker mounts
WARNING