Peerless-AV DST940 - Installation - Manual (Page 2)

2 of 10 ISSUED: 08-10-09 SHEET #: 139-9011-2 04-29-10
NOTE: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
• phillips screwdriver
• drill
• 3/8" drill bit
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity. See page one.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
WARNING
Table of Contents
Parts List.................................................................................................................................................................................3
Attaching Dual Cross Support to Extension Pipe ...................................................................................................................5
Attaching Extension Columns to Dual Cross Support ............................................................................................................5
Attaching Solid•Point
™ Column Mounts to Extension Columns ..............................................................................................6
(Optional) Attaching DSX750 to Ceiling Arm Boxes ...............................................................................................................7
Attaching Adapter Plate and Tilt Brackets to Ceiling Arm Boxes ............................................................................................7
Attaching Adapter Brackets to Screens .............................................................................................................................. 8-9
Attaching Adapter Brackets to Adapter Plate....................................................................................................................... 10