Warning, Lp q h, Attaching adapter brackets to adapter plate 7 – Peerless-AV DST940 - Installation User Manual

Page 10

10 of 10

ISSUED: 08-10-09 SHEET #: 139-9011-2 04-29-10

Hook adapter brackets (

P) to adapter plate (Q) as

shown in figure 7.1. Tighten safety/security screws

using allen wrench (

R) until safety/security screw

touches bottom of wall plate as shown in detail 4. To

adjust tilt of screens, loosen M10 x 15 mm penta-pin

screws (

L) of ceiling arm box (H) using M10 penta-

pin tool (

M) as shown in figure 7.2. Once desired tilt

is acquired retighten the screws.

Attaching Adapter Brackets To Adapter Plate

fig. 7.1

DETAIL 4

fig. 7.2

Security/Safety

Screws

All other brand and product names are trademarks or registered trademarks of their respective owners.

• Always use an assistant or mechanical lifting

equipment to safely lift and position the flat panel

screen.

• Do not tighten screws with excessive force.

Overtightening can cause damage to mount.

Tighten screws to 40 in. • lb (4.5 N.M.) maximum

torque.

WARNING